On the conditions for achieving ultra-fine grains via thermo-mechanical treatment

IMR OpenIR

	On the conditions for achieving ultra-fine grains via thermo-mechanical treatment
	C. J. Huang; H. Zhang; Y. J. Nan; D. Z. Li; Y. Y. Li
	2005
发表期刊	Journal of Materials Processing Technology
ISSN	0924-0136
卷号	160 期号:2 页码:123-127
摘要	A finite element analysis was performed to study a novel hot rolling process by which ultra-fine grains (UFG) were achieved. FE analysis shows that the formation of ultra-fine grains was caused by a combination of severe undercooling and intensive deformation. It is found that undercooling was greater than 180 K within the ultra-fine grained surface layer. It is suggested in this paper that severe undercooling could significantly enhance the efficiency of grain refinement in thermo-mechanical processes. Hence, ultra-fine grains were obtained via a relatively low reduction hot rolling process. Special hot compression tests, during which severe undercooling were introduced before deformation, were done to verify the effect of undercooling on grain refinement. Ultra-fine grains were achieved by compression at a reduction ratio of 0.7. The critical undercooling to achieve ultra-fine grains was about 200 K. (c) 2004 Elsevier B.V. All rights reserved.
部门归属	inst met sci & technol, new delhi 110016, india. chinese med univ, shenyang 110001, peoples r china.;huang, cj (reprint author), inst met sci & technol, new delhi 110016, india;cjhuang@imr.ac.cn
关键词	Ultra-fine Grains Hot Rolling Steel Strips Undercooling Strip Rolling Process Ferrite Steel Transformation Deformation Austenite
URL	查看原文
文献类型	期刊论文
条目标识符	http://ir.imr.ac.cn/handle/321006/34877
专题	中国科学院金属研究所
推荐引用方式 GB/T 7714	C. J. Huang,H. Zhang,Y. J. Nan,et al. On the conditions for achieving ultra-fine grains via thermo-mechanical treatment[J]. Journal of Materials Processing Technology,2005,160(2):123-127.
APA	C. J. Huang,H. Zhang,Y. J. Nan,D. Z. Li,&Y. Y. Li.(2005).On the conditions for achieving ultra-fine grains via thermo-mechanical treatment.Journal of Materials Processing Technology,160(2),123-127.
MLA	C. J. Huang,et al."On the conditions for achieving ultra-fine grains via thermo-mechanical treatment".Journal of Materials Processing Technology 160.2(2005):123-127.