IMR OpenIR
An attempt to correlate the change of the swept area (Delta A/b(2)) by mobile dislocations with the mechanism of the fatigue crack propagation rate (da/dN) in environmental hydrogen: Application in Inconel 690
Luo, XH; Habashi, M; Luo, XH (reprint author), Chinese Acad Sci, Inst Met Res, CAS Key Lab Nucl Mat & Safety Assessment, Shenyang, Liaoning, Peoples R China.
2018-01-02
发表期刊MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
ISSN0921-5093
卷号709页码:349-357
摘要The thermally activated dislocation motion due to plastic deformation in Inconel 690 has been carried out by performing tensile tests in air and in environmental hydrogen using the strain relaxation technique. The results show that the variation of - delta(Delta A/b(2)) or ln(V-H/V-Air) with epsilon(p) depends on the nickel content in the alloy and the microstructure, and generally increases with increasing Ni% for low value of epsilon(p) (tensile test). The maximum increase in the rate change was observed for the austenized and aged microstructure. On the other hand, fatigue crack propagation rate (da/dN) has been measured in the same environments. An attempt has been carried out to correlate the rate change - delta(Delta A/b(2)) or ln(V-H/V-Air) with the variation of (da/dN)(H) against (da/dN)(Air) (the variation of Omega) and has shown that for the austenized and aged microstructure, Omega is higher than those for stress relieved or only aged at 700 degrees C. These results are similar to those obtained by the thermal activation parameter - delta (Delta A/b(2)) or the ratio ln(V-H/V-Air). The maximum values of - delta (Delta A/b(2)) and Omega are obtained when the density of precipitates on the grain boundaries is higher than that in the matrix. In this case, intergranular fractures with fin slip lines features on the grain surfaces were observed. Finally, in the presence of environmental hydrogen, about the fatigue crack propagation rate, two relationships were established and expressed as: 1) in stages I and II: (Delta epsilon(p)/2) = Theta Delta K + Gamma and 2) only in stage II: (da/dN)(II) = c(II) (Delta epsilon(p) / 2)(lambda), where lambda approximate to m = 2, the power factor in Paris' law.; The thermally activated dislocation motion due to plastic deformation in Inconel 690 has been carried out by performing tensile tests in air and in environmental hydrogen using the strain relaxation technique. The results show that the variation of - delta(Delta A/b(2)) or ln(V-H/V-Air) with epsilon(p) depends on the nickel content in the alloy and the microstructure, and generally increases with increasing Ni% for low value of epsilon(p) (tensile test). The maximum increase in the rate change was observed for the austenized and aged microstructure. On the other hand, fatigue crack propagation rate (da/dN) has been measured in the same environments. An attempt has been carried out to correlate the rate change - delta(Delta A/b(2)) or ln(V-H/V-Air) with the variation of (da/dN)(H) against (da/dN)(Air) (the variation of Omega) and has shown that for the austenized and aged microstructure, Omega is higher than those for stress relieved or only aged at 700 degrees C. These results are similar to those obtained by the thermal activation parameter - delta (Delta A/b(2)) or the ratio ln(V-H/V-Air). The maximum values of - delta (Delta A/b(2)) and Omega are obtained when the density of precipitates on the grain boundaries is higher than that in the matrix. In this case, intergranular fractures with fin slip lines features on the grain surfaces were observed. Finally, in the presence of environmental hydrogen, about the fatigue crack propagation rate, two relationships were established and expressed as: 1) in stages I and II: (Delta epsilon(p)/2) = Theta Delta K + Gamma and 2) only in stage II: (da/dN)(II) = c(II) (Delta epsilon(p) / 2)(lambda), where lambda approximate to m = 2, the power factor in Paris' law.
部门归属[luo, xinghong] chinese acad sci, inst met res, cas key lab nucl mat & safety assessment, shenyang, liaoning, peoples r china ; [habashi, mahmoud] cnrs, paris, france
关键词Stress-corrosion Cracking Austenitic Stainless-steel Alloy-600 Nickel Water
学科领域Nanoscience & Nanotechnology ; Materials Science, Multidisciplinary ; Metallurgy & Metallurgical Engineering
收录类别SCI
语种英语
文献类型期刊论文
条目标识符http://ir.imr.ac.cn/handle/321006/79594
专题中国科学院金属研究所
通讯作者Luo, XH (reprint author), Chinese Acad Sci, Inst Met Res, CAS Key Lab Nucl Mat & Safety Assessment, Shenyang, Liaoning, Peoples R China.
推荐引用方式
GB/T 7714
Luo, XH,Habashi, M,Luo, XH . An attempt to correlate the change of the swept area (Delta A/b(2)) by mobile dislocations with the mechanism of the fatigue crack propagation rate (da/dN) in environmental hydrogen: Application in Inconel 690[J]. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING,2018,709:349-357.
APA Luo, XH,Habashi, M,&Luo, XH .(2018).An attempt to correlate the change of the swept area (Delta A/b(2)) by mobile dislocations with the mechanism of the fatigue crack propagation rate (da/dN) in environmental hydrogen: Application in Inconel 690.MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING,709,349-357.
MLA Luo, XH,et al."An attempt to correlate the change of the swept area (Delta A/b(2)) by mobile dislocations with the mechanism of the fatigue crack propagation rate (da/dN) in environmental hydrogen: Application in Inconel 690".MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING 709(2018):349-357.
条目包含的文件
条目无相关文件。
个性服务
推荐该条目
保存到收藏夹
查看访问统计
导出为Endnote文件
谷歌学术
谷歌学术中相似的文章
[Luo, XH]的文章
[Habashi, M]的文章
[Luo, XH (reprint author), Chinese Acad Sci, Inst Met Res, CAS Key Lab Nucl Mat & Safety Assessment, Shenyang, Liaoning, Peoples R China.]的文章
百度学术
百度学术中相似的文章
[Luo, XH]的文章
[Habashi, M]的文章
[Luo, XH (reprint author), Chinese Acad Sci, Inst Met Res, CAS Key Lab Nucl Mat & Safety Assessment, Shenyang, Liaoning, Peoples R China.]的文章
必应学术
必应学术中相似的文章
[Luo, XH]的文章
[Habashi, M]的文章
[Luo, XH (reprint author), Chinese Acad Sci, Inst Met Res, CAS Key Lab Nucl Mat & Safety Assessment, Shenyang, Liaoning, Peoples R China.]的文章
相关权益政策
暂无数据
收藏/分享
所有评论 (0)
暂无评论
 

除非特别说明,本系统中所有内容都受版权保护,并保留所有权利。