Knowledge Management System Of Institute of metal research，CAS
| Using ultrasound to improve the sequential post-synthesis modification method for making mesoporous Y zeolites | |
| Zhang, Rongxin; Zhong, Peinan; Arandiyan, Hamidreza; Guan, Yanan; Liu, Jinmin; Wang, Na; Jiao, Yilai; Fan, Xiaolei | |
| 2020-04-01 | |
| Source Publication | FRONTIERS OF CHEMICAL SCIENCE AND ENGINEERING
 |
| Volume | 14Issue:2Pages:275-287 |
| Abstract | Mesoporous Y zeolites were prepared by the sequential chemical dealumination (using chelating agents such as ethylenediaminetetraacetic acid, H(4)EDTA, and citric acid aqueous solutions) and alkaline desilication (using sodium hydroxide, NaOH, aqueous solutions) treatments. Specifically, the ultrasound-assisted alkaline treatment (i.e., ultrasonic treatment) was proposed as the alternative to conventional alkaline treatments which are performed under hydrothermal conditions. In comparison with the hydrothermal alkaline treatment, the ultrasonic treatment showed the comparatively enhanced efficiency (with the reduced treatment time, i.e., 5 min vs. 30 min, all with 0.2 mol center dot L-1 NaOH at 65 degrees C) in treating the deal-uminated Y zeolites for creating mesoporosity. For example, after the treatment of a dealuminated zeolite Y (using 0.1 mol center dot L-1 H4EDTA at 100 degrees C for 6 h), the ultrasonic treatment produced the mesoporous zeolite Y with the specific external surface area (S-external) of 160 m(2)center dot g center dot(-1)and mesopore volume (V-meso) of 0.22 cm(3)center dot g(-1), being slightly higher than that by the conventional method (i.e., S-extemal= 128 m(2)center dot g(-1) and V-meso = 0.19 cm(3)center dot g(-1)). The acidic property and catalytic activity (in catalytic cracking of n-octane) of mesoporous Y zeolites obtained by the two methods were comparable. The ultrasonic desilication treatment was found to be generic, also being effective to treat the dealuminated Y zeolites by citric acid. Additionally, the first step of chemical dealumination treatment was crucial to enable the effective creation of mesopores in the parent Y zeolite (with a silicon-to-aluminium ratio, Si/Al = 2.6) regardless of the subsequent alkaline desilication treatment (i.e., ultrasonic or hydrothermal). Therefore, appropriate selection of the condition of the chemical dealumination treatment based on the property of parent zeolites, such as Si/Al ratio and crystallinity, is important for making mesoporous zeolites effectively. |
| DOI | 10.1007/s11705-019-1905-1 |
| WOS ID | WOS:000516350100002 |
| Citation statistics | |
| Document Type | 期刊论文 |
| Identifier | http://ir.imr.ac.cn/handle/321006/83113 |
| Collection | 中国科学院金属研究所 |
| Recommended Citation GB/T 7714 | Zhang, Rongxin,Zhong, Peinan,Arandiyan, Hamidreza,et al. Using ultrasound to improve the sequential post-synthesis modification method for making mesoporous Y zeolites[J]. FRONTIERS OF CHEMICAL SCIENCE AND ENGINEERING,2020,14(2):275-287. |
| APA | Zhang, Rongxin.,Zhong, Peinan.,Arandiyan, Hamidreza.,Guan, Yanan.,Liu, Jinmin.,...&Fan, Xiaolei.(2020).Using ultrasound to improve the sequential post-synthesis modification method for making mesoporous Y zeolites.FRONTIERS OF CHEMICAL SCIENCE AND ENGINEERING,14(2),275-287. |
| MLA | Zhang, Rongxin,et al."Using ultrasound to improve the sequential post-synthesis modification method for making mesoporous Y zeolites".FRONTIERS OF CHEMICAL SCIENCE AND ENGINEERING 14.2(2020):275-287. |
| Files in This Item: | There are no files associated with this item. | |||||
Items in the repository are protected by copyright, with all rights reserved, unless otherwise indicated.
Edit Comment