| Prediction of microstructure and mechanical properties of hot rolled steel strip: Part I - Description of models | |
| Lan, YJ; Li, DZ; Sha, XC; Li, YY | |
| Corresponding Author | Lan, YJ(yjlan@imr.ac.cn) |
| 2004-07-01 | |
| Source Publication | STEEL RESEARCH INTERNATIONAL
 |
| ISSN | 0177-4832 |
| Volume | 75Issue:7Pages:462-467 |
| Abstract | A metallurgical through-process model is presented which describes the microstructural evolution and predicts the final mechanical properties of low carbon steel during hot strip rolling. Process models concern the thermal and deformation phenomena, which take into account the strain, strain rate and temperature distribution along the length of the strip. And the metallurgical models cover five modules, which are (i) austenitization of cast slab in reheating furnace, (ii) recrystallization of austenite in hot rolling, (iii) phase transformation of austenite-ferrite in laminar cooling on the run-out-table, (iv) grain growth after coiling, and (v) final structure-mechanical properties of products. Temperature is the main parameter and has dominant influence on the microstrutural evolution and the mechanical properties. The related temperature variation in hot strip rolling concerns air cooling, scaling, water cooling, heat transmission by roll contact, heat generation by deformation and friction. These complex factors are incorporated into the thermal models to simulate the temperature distribution along the length of the strip from the reheating furnace exit to the down-coiler. A self-learning algorithm is employed to improve the calculation accuracy and the computational temperatures are compared with the measured ones at typical locations. In the structure-property relationships, two key process parameters (e.g., finishing exit temperature (FT7) and coiling temperature (CT)) are introduced in the model to consider the influence of morphology of microstructure on mechanical properties. |
| Keyword | process models metallurgical models mechanical properties hot strip steel |
| Indexed By | SCI |
| Language | 英语 |
| WOS Research Area | Metallurgy & Metallurgical Engineering |
| WOS Subject | Metallurgy & Metallurgical Engineering |
| WOS ID | WOS:000222994700006 |
| Publisher | VERLAG STAHLEISEN MBH |
| Citation statistics | |
| Document Type | 期刊论文 |
| Identifier | http://ir.imr.ac.cn/handle/321006/80850 |
| Collection | 中国科学院金属研究所 |
| Corresponding Author | Lan, YJ |
| Affiliation | 1.Chinese Acad Sci, Met Res Inst, Shenyang 110016, Peoples R China 2.Anshan Iron & Steel Grp Corp, Anshan, Peoples R China |
| Recommended Citation GB/T 7714 | Lan, YJ,Li, DZ,Sha, XC,et al. Prediction of microstructure and mechanical properties of hot rolled steel strip: Part I - Description of models[J]. STEEL RESEARCH INTERNATIONAL,2004,75(7):462-467. |
| APA | Lan, YJ,Li, DZ,Sha, XC,&Li, YY.(2004).Prediction of microstructure and mechanical properties of hot rolled steel strip: Part I - Description of models.STEEL RESEARCH INTERNATIONAL,75(7),462-467. |
| MLA | Lan, YJ,et al."Prediction of microstructure and mechanical properties of hot rolled steel strip: Part I - Description of models".STEEL RESEARCH INTERNATIONAL 75.7(2004):462-467. |
| Files in This Item: | There are no files associated with this item. | |||||
Items in the repository are protected by copyright, with all rights reserved, unless otherwise indicated.
Edit Comment